Frameless bathroom mirror are perfect candidates for framing, even by a beginner. Because they are usually attached to the wall with glue, you do not have to worry about removing the mirror, finding a helper or handling the weight of a large piece of glass. Stock casting, there are home centers, come in a variety of styles. Using rosettes, which are decorative wooden windows, in the corners eliminates the need for more difficult angled incisions.
12 Photos Gallery of: Design Of Frameless Bathroom Mirror
Measure at the top of the frameless bathroom mirror. Use a pen to mark a length of decorative casting with this measurement. Set the saw to zero and place the casting, decorative upwards on the saw platform against the back fence (edge). Target your brand with the center of the cutting edge of the saw. Activate the saw and lower the handle, cut the trim to the correct length. Place the trim along the top edge of the mirror and check the fit. It should be exactly as long as the mirror is wide, which does not extend beyond the corners. If it is too long, mark it for trimming and cut again with the saw blade.
Cut the shaping pieces the exact length of the frameless bathroom mirror edges leaves an opening at each corner where the rosette boxes will fit. Measure the bottom and side pieces using the same method, always making sure each piece is the same length as the mirror edge where it will be installed. Easily remove any uneven edges from cuts. Spread the newspaper or a dust sheet onto a flat surface. Place the molding pieces on the newspaper or dust sheet, decorative side up. Paint or bet any piece as desired. Allow the pieces to dry before installing.